Lompat ke konten Lompat ke sidebar Lompat ke footer

2001 Toyota Avalon Cooling Fan Relay Diagram

Joined

·

27 Posts

Discussion Starter · #1 ·

1998 Avalon xls

Hello all, today I noticed both of my cooling fans come on immediately when engine is started. Engine was cold and the outside temperature was around 75 degrees. I thought neither fan was supposed to run until engine reached operating temp, then one would run. And the second is supposed to come on when A/C is on or engine reached a specific higher temp? Can someone please explain the correct operation of the fans? and how they are wired, etc.
I appreciate any info and help.

Kingdom934

Joined

·

9,188 Posts

Most cars when the AC is running, both fans should kick on (at lease my 98 V6 and 04 V6 Camry does). Boths should also kick on if the coolant sender is disconnect/bad. I can't tell you in details on when and why they should come on at certain times though.

You got any CEL on?

Joined

·

27 Posts

Discussion Starter · #3 ·

I checked a few things out. I realized the fans were both stuck on HIGH. I pulled out Fan Relay no. 1 and Fan Relay no. 2 and both caused the respective fan to stop but then would come back on when the relay was put back in. I thought maybe the relays were stuck so I put fan relay no. 1 in and out a few times and this caused it to finally open and stop the fan. I did the same for fan relay no. 2 and it also stopped the fan. It seems strange that BOTH relays were stuck at the same time? I then found the ECT switch on the engine block by the coolant return line from radiator. I disconnected it but the fans would only come on if I grounded the wire, the fans both came on at low speed. But I thought the fans were supposed to come on when the switch was disconnected (open circuit, not grounded). I should mention the engine was cold when I tested this, so the switch should've been closed.
There is no check engine light on.

Joined

·

27 Posts

Discussion Starter · #4 ·

So the fans are stuck on HIGH again. I can't seem to pinpoint which relay or switch is causing the problem. It seems to be almost impossible to find an electrical diagram for the cooling fan system. I've come across random posts and diagrams but none that are definitely the right one. Some diagrams show two water temp switches but I've only found one where the lower hose connects to the engine, the sensor next to it has a two wire connector so I believe that is for the ecu to monitor return coolant temp. But again, without knowing for sure what controls what and not knowing exactly what order things are wired makes it very frustrating.
I believe whatever controls the relays for HIGH fan operation is the problem and not the relays themselves. I was able to get the fans to stop one or twice by tapping on the relay block that holds fan relays 2 and 3. But right after starting the engine fans came back on high and I'm not able to get the fans to stop anymore. None of the slots that hold the relays are damaged or pushed in. But I may take the block apart to check wires inside.

BMR

Joined

·

14,826 Posts

I can shed some light on the coolant temperature sensors.

There is one 2-wire sensor in the thermostat housing where the upper radiator hose connects. This is the ECT sensor monitored by the ECU. It does not control the fans.

There is another 1-wire sensor in that same housing that feeds the temp gauge in the instrument cluster. It does not control the fans.

The third one that controls the fans, I think is the one you found where the lower radiator hose connects. I'm not sure if it's a switch (on/off), or a thermister with resistance varying with temperature.

Hope that helps a little.

Joined

·

27 Posts

Discussion Starter · #6 ·

Thanks for the response. I found that the switch is on/off. When I grounded the connector the fans both turned on Low speed. This was when the fans weren't malfunctioning on High speed constantly.

I think I found the problem. The a/c pressure switch. When I disconnected the 4 wire connector the fans kept running. I tried jumping two of the wires and nothing happened. I assume that was for the compressor control. Then I jumped the other two wires and the fans stopped. I also heard fan relay 1 and 2 click open at the same time. The problem is that in order to change that switch I'd have to empty and refill the system! Why couldn't they put a schrader valve under the a/c pressure switch like other cars I've worked on over the years??

Joined

·

3,549 Posts

BBBind.com has a schematic so you can see the entire wiring/relays together.

Looks like the a/c single pressure switch is the portion that is open.
The compressor is protected by the other part( the dual pressure switch).
If you bypass the single pressure switch the water temp switch #1 will still turn on fans at high temp and switch #2 a lower temp.

Joined

·

27 Posts

Discussion Starter · #8 ·

The idea of bypassing it did cross my mind. I'd like to add that I had also checked for continuity at the a/c switch across the two pairs of terminals. The compressor control part of the switch had continuity, while the fan control part did not.

As far as bypassing it, I would rather not cut the two wires from the connector in order to splice them together. Is there anywhere else I can jump out the circuit temporarily in case I decide to replace the a/c pressure switch in the future??

I located one water temp switch for the LOW speed fan operation, it is right next to the lower radiator hose on the engine. When I grounded the connector both fans came on at LOW speed. Where is the second water temp switch located? (The switch for HIGH speed) I'd like to be able to test it the same way so I know the fans will come on High speed if needed.

Thanks for the help.

Joined

·

3,549 Posts

Try back probing with couple of t-pins. Tape it up see if it holds.

Run the ECT up to test high-speed fan circuit. Switch must be located thermostat area.

Joined

·

8 Posts

Hi, I am trying to replace the coolant temp sensor in my 95 avalon. I need to replace the one that controls the fans. I understand it is near a lower radiator/hose connection but not exactly sure. Anyone have more specific instructions for me please. Sorry for such simple question fairly new to DIY maintenance but thoroughly enjoying it. Thanks.

Source: https://www.toyotanation.com/threads/cooling-fan-operation.1362161/

Posted by: anniebefickeelpaed.blogspot.com

Posting Komentar untuk "2001 Toyota Avalon Cooling Fan Relay Diagram"